>> HOME | >>PRODUCTS | UNIVERSAL PLASTER

Alfill UNIVERSAL PLASTER

 ALFILL UNIVERSAL PLASTER Fiber Reinforced Multi-Purpose Cement-Based Plaster Mortar

Providing strong adhesion, Universal Plaster is applied quickly and easily. Universal Plaster, which is resistant to crack formation, is minimally affected by weather conditions thanks to its water vapor permeability.

Package: 25Kg

Usage Areas: It is a plaster that can be applied indoor and outdoor, on walls and ceilings. It can be used as a finishing coat or as a sub-plaster for decorative applications (such as satin plaster, tiles, decorative stone, BTB, garden walls and under-ceramic plaster).

Appearance Gray or white powder
Powder Density 1,55 kg/lt
Water Mixing Ratio 5 – 6 lt water / 25 kg powder
Resting Time 5 – 10 minutes
Pot Life About 2 hours
Application Temperature Between +5°C and +35°C
Dry Film Thickness > 400μm (E5) (EN 1062-1)
Grain Size Thick; <1500μm (S3) (EN 1062-1)
Water Transfer Rate Low; ≤ 0.1 kg / (m².h0,5) (W3) (EN 1062-1)
Flexural Strength > 4 N / mm² (EN 196-1)
Compressive Strength > 10 N / mm² (EN 12190)
Service Temperature -20°C / +70°C

Consumption:

1 – 2.5 kg / m² (Depends on the application method)

Attention:

Avoid application at temperatures below 5 ° C and above + 35 ° C. Avoid application in frozen areas, where there is a risk of freezing within 24 hours or in areas open to direct sunlight and wind. After the application, make sure that there is no snowfall or severe cold until the cement sets (approximately 1 week). Do not add powder and water to the expired mortar.

Be careful not to use the boards that have lost their properties by staying in the sun for a long time.

Packaging and Shelf Life:

In 25 kg craft bags. It can be stored for 12 months on the pallet in a 10-fold stacked in a dry and unopened package.

©[2020] Alfill | World Of Construction Chemicals