>> HOME | >>PRODUCTS | UNIVERSAL SATIN PLASTER

Alfill UNIVERSAL SATIN PLASTER

 ALFILL UNIVERSAL SATIN PLASTER Fiber Reinforced Cement Based Satin Plaster Mortar

Providing high adhesion on mineral surfaces, Universal Satin Plaster creates a smooth surface before painting. Thanks to its long application time, it can be used comfortably and without waste.

Package: 20Kg

Usage Areas: Used as a fine finishing plaster on traditional and ready-mixed cement-based plaster applications indoors and outdoors. It is plaster that can be applied indoor and outdoor, on walls and ceilings. It can be used as a finishing plaster or for decorative applications.

Appearance Gray or white powder
Powder Density 1,35 kg/lt
Water Mixing Ratio 5.5 – 7.5 lt water / 20 kg powder
Resting Time 5 – 10 minutes
Pot Life About 2 hours
Application Temperature Between +5°C to +35°C
Flexural Strength > 1.5 N / mm² (EN 196-1)
Compressive Strength > 5 N/mm² (EN 12190)
Service Temperature -20°C / +70°C

Consumption:

1 – 1.7 kg / m² (Depends on the application method)

Attention:

Avoid application at temperatures below + 5 ° C and above + 35 ° C. Avoid application in frozen areas, where there is a risk of freezing within 24 hours or in areas open to direct sunlight and wind. After the application, make sure that there is no snowfall or severe cold until the cement sets (approximately 1 week). Do not add powder and water to the expired mortar.

Be careful not to use the boards that have lost their properties by staying in the sun for a long time.

Packaging and Shelf Life:

In 20 kg craft bags. It can be stored for 12 months on a pallet in a 10-fold stacked in a dry and intact package.

©[2020] Alfill | World Of Construction Chemicals